How to manual feed paper

 · 1. Adjust the paper guides to the width of the loaded envelope as shown in the figure. The paper guides move together. 2. Gently insert the envelope until it touches the back of the printer while supporting the envelope with hands as shown in the figure. When the envelope is loaded, it is sent into the slot a little. You can select Automatic or the appropriate tray from the Source is: drop-down list in the Properties window. Click Apply in the Paper/Quality tab. Please note that you cannot select Manual Feed from the drop-down list. Click Apply to accept the settings, and then .  · Slightly jiggle the paper up and down if necessary. In the print settings screen, select the manual feed tray for the paper source, then select the size and type of the loaded paper from the print settings screen. To print continuously, wait until printing is complete, then load the next sheet.

Select Paper Feed from the dropdown menu. In the All Pages From dropdown, select Tray 4 (Manual Feed). 5 Once all your settings are set, click Print Your document should appear in Papercut shortly to be released. Fig 5 - Xerox Features Fig 6 - Xerox Features - Binding Options Fig 7 - Xerox Features - Heavyweight Fig 8 - Paper Feed - Manual Tray. Load a single sheet of paper or thick media, printable side up and short edge first, in the center of the rear paper feed slot. Push it approximately 2 inches (5 cm) into the slot. Load an envelope, short edge first with the flap facing down and to the left, in the center of the rear paper feed slot. 2. Open the manual feed slot cover. 3. Use both hands to adjust the manual feed guides to the size paper you are using. 4. Using both hands, put one full sheet of paper in the manual feed slot and when you feel the machine pull it in, let go. Please make sure: The paper is straight and in the correct position in the manual feed slot. - Do not.

Load paper in the manual feed tray. Flatten the paper if it's curled. Don't try to uncurl Photo Paper Plus Semi-gloss SG This may cause cracks on the surface of the paper and reduce the print quality. Open the paper support (1) of the manual feed tray, and pull it out. Gently open the paper output tray (2). If the inner cover (A) is open, close it. Pull out the tray extension when loading large paper. 3. Spread the paper guides apart. Slide the paper guides outward. 4. Insert the paper into the manual feed slot until the paper stops. Load the paper in portrait orientation (with the short edge toward the machine), with the print side face up. Page of the user manual here indicates card stock (up to lb) is supported in the top tray but only plain paper is supported in the bottom tray. I looked over my carefully, it does not appear there is any way to manually feed media.